![]() A larger pin diameter would then be required. If the pin is made from steel with physical properties lower in value than the steel used for the rod, the pin may not develop the strength of the rod and either shear or bend. If inadequate, a larger diameter pin must be selected. The pin must be investigated for bending. Table III is provided for reference that indicates the maximum Grip, Pin & Tap sizes for each Clevis size.įor any combination of tap size and pin diameter shown, the pin in double shear will develop the strength of the rod if both the rod and pin are made from steel having the same physical properties. ![]() Use Table I to select the proper combination of tap size and pin diameter for any given size of clevis. ![]() ![]() The maximum tap size (U dimension) shown in Table II is for reference purposes only and should be used only to determine the largest tap diameter the clevis may accommodate without considering the pin diameter. regular nut eye bolt 1/4x2 regular nut eye bolt 1/2x3-1/4 turnbuckle 1/2 turnbuckle 1/4 wire end protection guard 1/4 wire rope clips 3/8 Request Notice If you request drawing or general block or standard block Please attach references for information to prepare drawing. Available for SOLIDWORKS, Inventor, Creo, CATIA, Solid Edge, autoCAD, Revit and many more CAD software but also as STEP, STL, IGES, STL, DWG, DXF and more neutral CAD formats. Maximum working loads have been established with a design factor of 5:1 or 3:1 (AISC) using the maximum pin diameter, the resulting net area of the eye at the pin hole, and the expected ultimate tensile strength of C-1035 steel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |